Kodak I7300 User Manual download pdf (Page 77)

4-6 A-61133 March 2003

3. Image Mark Position. Select the image mark position on the film.

• Choose Lead Edge if the image marks are aligned with the lead

edge of the image.

• Choose Other if the image marks are located in any other

position than the lead edge and then select Setup… to display

the Image Mark Position dialog box. See the section entitled,

“Determining the image mark position” later in this chapter for

more information.

4. Image Mark Polarity. Select either Positive or Negative.

• Choose Positive if the image mark is clear and the film has a

black background.

• Choose Negative if the image mark is black and the film has a

clear background.

5. Count Splices. Make a selection from the Count Splices list box if

you have splices on your film. Count Splices specifies whether

splices on the film are to be counted as image marks. For more

information about film splicing, see Appendix A, Microfilm

Information.

• No — do not count splices.

• Yes, as Large — count splices as large image marks.

• Yes, as Medium — count splices as medium image marks.

• Yes, as Small — count splices as small image marks.

6. Image Management Code. Check the Enable checkbox to enable

the scanner to read Kodak’s Image Management Code (IMC). For

more information about Image Management Code see Appendix C,

Glossary.

NOTE: This option only works with Kodak’s Image Management

Code.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 173 174

No comments

Kodak I7300 User Manual Page 77