Kodak I7300 User Manual Page 49

  • Download
  • Add to my manuals
  • Print
  • Page
    / 174
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 48
3-2 A-61133 March 2003
Opening an
application
The Application Software allows you to select an existing application or
create a new application. Chapter 4, Application Setup, provides
procedures on setting up new applications.
To use an existing application:
Select the desired application from the Application drop-down list box
on the Control Panel:
Once an application is selected, you can make use of all its parameters
to retrieve images from film, use the image processing and annotation
options and save, print or e-mail the images as desired.
Retrieving images
from film
The scanner can handle a variety of film formats and methods of
indexing. It has search programs to handle duo, duplex, duo/duplex or
simplex film formats with one-level, two-level, or three-level image
marks. It can also be used to do odometer searches of film that
contains no, or poor quality, image marks. For more information see the
section entitled, “Using the odometer mode” later in this chapter.
When retrieval is under CAR control, you must have CAR Interface
Software installed and the CAR parameters defined in the CAR setup.
IMPORTANT: Before retrieving images from microfilm, be sure the
kinks are removed from the film. Failure to remove the
kinks may cause threading problems.
To retrieve images from film:
Insert the microfilm, which contains the desired image in the film slot
of the scanner. You can then navigate through the film in several ways.
For more information on the following features, see Chapter 2.
Ø By using the Navigate menu.
Ø By using the navigation buttons on the Control Panel.
NOTE: You must enable Plus Indexing (typically, Plus Indexing is
disabled) in the current application when using Batch Scan
or plussing across chapters to allow you to cross chapter
boundaries. For more information see the section entitled,
“Setting values on the General tab” in Chapter 4.
Ø By using the Image Retrieval keypad.
Page view 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 173 174

Comments to this Manuals

No comments