Kodak I7300 User Manual download pdf (Page 159)

A-61133 March 2003 D-5

3890 film, Film tab

template settings

The information below includes only the values that are different from

the system default settings. For more information about the Film tab,

see the section entitled “Setting values on the Film tab” in Chapter 4.

Template specific settings

1. Film – Format: Duplex.

2. Film – Reduction: 50.

3. Overscan – Images Before: 1.

4. Overscan – Images After: 2.

5. Image Area: User Defined.

6. Auto Scan Length: Enabled.

Explanation of settings (see the illustration that follows)

1. Film – Format: The format must be Duplex.

2. Film – Reduction: The reduction must be 50X.

3. Overscan (Images Before and Images After): Due to the large

reduction ratio, poor image alignment within the film frame, and the

small distance between image marks, Overscan must be used. No

more than 6 images should be scanned at one time.

4. Image Area: Since Auto Scan Length determines only the scan length,

the Image Area setting must be used to determine scan width. A User

Defined image area setting was used. This setting may need to be

modified so the specified scan width accommodates your specific

needs, i.e., to eliminate the image marks (or other extraneous

information outside the image) for display and processing. Be sure to

specify an area that accommodates large business-size checks, and

allows for potential image location irregularity on the film, to prevent

truncation of images.

5. Auto Scan Length: Allows the software to determine scan length

based upon the distance between image marks.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 173 174

No comments

Kodak I7300 User Manual Page 159