Kodak RFS 3570 User Manual download pdf (Page 77)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Using the KODAK Driver for Adobe Photoshop (Macintosh) 5-21

“Crop” the Image

16. Follow part A or part B of this step depending on whether or not you

want to crop the image.

A. If you do not want to crop the image, click once on the image to

remove the selection (cropping) rectangle.

B. If you want to crop the image, drag the mouse within the image,

pulling the selection rectangle around the portion of the image

you wish to scan; this “crops” the image. Only the cropped area

will be scanned into Photoshop (see next step); if you do not

select a specific portion, the entire image will be scanned. Note

that I

MAGE SIZE, shown below the image, changes to reflect the size

of the area you have selected.

NOTES: To change the size of an existing selected area, press and hold

down the Command ( ) key. With the key down, when you move the

crossbar cursor over the edge of the selection rectangle, the crossbar

turns into arrows. Drag the mouse on any corner or side of the selection

rectangle, changing the size of the selection rectangle. Then release the

Command ( ) key and mouse button.

To move an existing selection rectangle, place the crossbar cursor inside

the selection rectangle. Press and hold down the Command ( ) key; the

crossbar becomes a hand. Drag the cursor, moving the selection rect-

angle to its new location. Then release the Command ( ) key and mouse

button.

To deselect an area, click once inside or outside the selection rectangle.

Scan the Image into Photoshop

17. Click SCAN. The KODAK Driver window closes, a progress box

appears, and then the scan appears in a Photoshop window.

NOTE: If this is the first time that you are completing a scan during this work

session, or if you notice water spots or bubbles in the scanned image at any

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 219 220

No comments

Kodak RFS 3570 User Manual Page 77