Kodak i600 Series User Manual download pdf (Page 67)

6-14 A-61500 April 2007

Problem Possible Solution

Long documents are not feeding or are

jamming

Make sure that:

• the elevator tray extender is pulled out to provide support for long

documents.

• the output tray is adjusted for the length of the documents being

scanned.

• the output tray is installed properly.

Roller marks appear on the documents

after scanning

Clean the feed module rollers, separation rollers and transport rollers.

Vertical streaks appear on the image Make sure that:

• when you calibrate the scanner that you are using a good, clean

calibration target and that the imaging guides are clean. Use the

calibration target provided with your scanner. See Chapter 5,

Maintenance.

The enhanced printer is not printing as

desired

If you are having problems printing on scanned documents:

• verify that the ink cartridge is not empty.

• make sure that the ink cartridge is properly installed in the Enhanced

Printer.

• make sure that the ink cartridge is located in the correct position for

printing.

• make sure that the ink cartridge carrier is properly seated in its slot.

• verify that all printer connectors are securely fastened and that the

printer cable is securely attached.

• verify that the printer has been enabled through the host and that the

expected print string has been specified.

White lines appear at the top of the

image and run through the documents

• The imaging guides may be dirty. See Chapter 5, Maintenance.

• Check for scratches on the imaging guides. If scratches are on the

imaging guides, replace them.

Side guides will not move

• Remove all documents from the elevator tray and be sure the locking

switch is in the unlocked position.

1 2 ... 62 63 64 65 66 67 68 69 70

No comments

Kodak i600 Series User Manual Page 67