Kodak i600 Series User Manual download pdf (Page 17)

A-61500 April 2007 3-3

Document

preparation

Before you begin scanning documents, make certain the documents

can be fed through the scanner easily.

• A batch of documents to be fed into the scanner must be arranged so

the leading edges of all documents are aligned and centered under

the feed module; this allows the feeder to introduce documents into

the scanner one at a time.

• Staples and paper clips in documents may damage the scanner and

documents. Remove all staples and paper clips before scanning.

• Documents with missing corners, perforated edges, hole punches in

the margins, irregular and curled edges, torn, damaged, or crushed

pages can be transported successfully through the scanner.

However, no scanner can transport every possible type of damaged

paper. If in doubt about whether a specific damaged document can

be transported through the scanner, place the document in a clear

protective sleeve with the lead edge of the document aligned with the

folded edge of the sleeve. Sleeves should be manually fed, one at a

time, folded edge first, while using the gap release lever. Ultrasonic

multi-feed detection is not recommended when using plastic sleeves.

NOTE: When scanning documents in a clear protective sleeve, the

elevator tray side guides must be aligned to accommodate the

width of the sleeve.

Kodak scanners have been tested with a range of documents that

represent the broad spectrum of document types found in the most

common business applications. Optimal scanner performance is

achieved when scanning documents within the recommended

document specifications listed below. Scanning documents outside of

these specifications may lead to undesirable results in terms of scanner

reliability, image quality, and/or consumable life.

Materials:

• Virgin, recycled and photographic papers

• Clear protective sleeves meeting the size and thickness

requirements in this section

Paper Types: Bond, Laser, Inkjet, Offset

Paper Weights: The elevator tray handles a broad range of paper

weights from 45 to 200 g/m

(12 to 110 lb.). The Kodak Feeder Kit for

Ultra Lightweight Paper can handle paper weights from 25 to 75 g/m

(7 to 20 lbs).

Minimum Document Size: 6.4 x 6.4 cm (2.5 x 2.5 in.). Documents as

small as 5 cm (2 in.) (i.e. business cards) can be center-fed, in portrait

orientation one at a time.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 69 70

Comments to this Manuals

No comments

Kodak i600 Series User Manual Page 17

Comments to this Manuals

Related products and manuals for Multifunctionals Kodak i600 Series