Kodak i600 Series User Manual download pdf (Page 23)

A-61500 April 2007 3-9

Feeding documents

using multi-feed

detection

The scanner has three multi-feed detection sensors. When Multi-feed

detection is enabled, adjust the side guides so the documents fully

cover at least one sensor. If the document partially covers a sensor,

false multi-feeds may occur.

Automatic feeding To scan a batch of documents follow the guidelines for size, type,

quantity, etc., outlined in the “Document preparation” section.

For faster throughput, place documents into the elevator tray in

landscape orientation (longer side as the leading edge).

IMPORTANT: Staples and paper clips on documents may damage the

scanner. Remove all staples and paper clips before

scanning.

1. Align the leading edges of the stacked documents.

2. Position the stack of the documents, face up in the elevator tray so it

covers the paper present sensor.

3. Adjust the elevator tray side guides.

4. Adjust the output tray position, if necessary.

5. Adjust the output tray end stop, if necessary.

Depending on how your scanner is set up, your documents will

automatically start scanning, or you may need to press the Start/

Resume button to begin scanning.

Continuous feeding Continuous feeding can be used when you want to scan small batches

of documents (less than 25).

When the scanner is configured for continuous feeding, the elevator

tray is raised to a position where approximately 25 documents can be

loaded. The elevator tray will remain in this position to allow more

documents to be loaded to the bottom of the stack.

To continuously feed documents, follow Steps 1 through 5 above. As

the documents are being scanned, you can continuously add a batch of

documents to the bottom of the stack.

NOTE: Depending on how your scanner is configured, the transport will

stop when the Transport Timeout has been reached.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 69 70

No comments

Kodak i600 Series User Manual Page 23