Kodak 7520 User Manual Page 23
- Page / 127
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
A-61140 January 2000 3-3
Temporary
operating values
Each of the 18 modes programmed at the time of installation contain
definitions that affect the output of the scanner. Each mode is
programmed to conform to the output requirements of a particular
application or group of applications.
There may be instances, however, when a particular application requires
some variation of an existing mode. In such instances, mode definitions
may be changed using available function codes. See Chapter 4,
Function Codes, for a listing and description of the available function
codes.
NOTE: Changes to mode definitions remain in effect until another
mode is selected or the side panel switch is turned off. The
original mode definition is only affected by these changes if the
mode overrides are saved (the mode override option may be
selected at installation and if selected, a plus sign (+) appears
in the first line of the status display).
- Document Scanner 7520 1
- Scienceä 2
- Acoustic Emission 3
- 1 Introduction 5
- 1-2 A-61140 January 2000 6
- A-61140 January 2000 1-3 7
- For European units only: 8
- Status display 9
- Operating keys and 10
- Operating keys and indicators 11
- Confirmation tone/alarm 11
- 2 Getting Started 12
- Selecting the 13
- Calibrating the 13
- Preparing 14
- Adjusting the feed 15
- Bottom document 16
- Adjusting the separator 17
- Adjusting the side 18
- Adjusting the exit 19
- Standard position 20
- 10° from standard position 20
- 20° from standard position 20
- 3 Operating the Scanner 21
- 3-2 A-61144 January 2000 22
- Temporary 23
- Feeding documents 24
- Feeding thick 26
- 4 Function Codes 28
- Function code 29
- A-61140 January 2000 4-3 30
- Function code listing 31
- A-61140 January 2000 4-5 32
- 4-6 A-61140 January 2000 33
- A-61140 January 2000 4-7 34
- 5 Maintenance 35
- Daily maintenance 36
- A-61140 January 2000 5-3 37
- Red arrow 38
- Red rectangle 38
- Cleaning the feed and 39
- 5-6 A-61140 January 1999 40
- Cleaning the feeder 41
- 5-8 A-61140 January 1999 42
- Cleaning the paper path 43
- Weekly maintenance 44
- A-61140 January 2000 5-11 45
- 5-12 A-61140 January 1999 46
- Cleaning the cabinet 47
- Replacement 48
- A-61140 January 2000 5-15 49
- 5-16 A-61140 January 1999 50
- Replacing the imaging 51
- 5-18 A-61140 January 1999 52
- Replacing the feeder 54
- A-61140 January 2000 5-21 55
- Ordering 56
- Ordering cleaning 56
- 6 Operator Messages 57
- Controlled power 58
- Operator message listing 59
- 6-4 A-61140 January 2000 60
- A-61140 January 2000 6-5 61
- 6-6 A-61140 January 2000 62
- A-61140 January 2000 6-7 63
- 6-8 A-61140 January 2000 64
- A-61140 January 2000 6-9 65
- 7 Troubleshooting 66
- 7-2 A-61140 January 2000 67
- Clearing the 68
- Clearing documents 69
- The feeder area 70
- Horizontal transport 71
- A-61140 January 2000 7-7 72
- Vertical transport plate 73
- Document exit and 75
- Removing non-jammed 75
- 8 Accessories 76
- 8-2 A-61140 January 2000 77
- Using the Bar Code Reader 78
- 8-4 A-61140 January 2000 79
- Bar code placement 80
- Enabling bar 81
- Enabling the bar 81
- Performing a bar 82
- Using the Evaluate 83
- A-61140 January 2000 8-9 84
- Front imaging 85
- Vertical transport 85
- Rear imaging guide 85
- the front of the 86
- Put BC Doc Close 87
- Door, Press Enter 87
- A-61140 January 2000 8-13 88
- Evaluating test results 89
- A-61140 January 2000 8-15 90
- 8-16 A-61140 January 2000 91
- Using the Display 92
- BC Type = 93
- *XXXXXXXXXXXXX 93
- Using the Read Rate 94
- Using the Footswitch 95
- Footswitch 96
- Released actions 96
- Using the Patch Reader 97
- 98
- Patch Reading 99
- Changing the 100
- Using the Document Printer 101
- Front and rear 102
- Document Printer 102
- Vertical start print 103
- Horizontal print 104
- A-61140 January 2000 8-31 105
- Using the Print 106
- Test function 106
- Cleaning the ink 107
- Ink cartridge 108
- Bladder (inside ink 109
- Press spring clips 110
- Cable magnet 110
- (not shown) 110
- Replacing the ink 112
- A-61140 January 2000 8-39 113
- Appendix A Basic Concepts 115
- Image addresses 116
- Assigning an image 117
- Using the Next key 117
- Using Function Code F92 118
- Image address 119
- Indexing schemes 119
- Single level indexing 120
- Two level indexing 121
- Two level offset indexing 122
- Three level indexing 123
- Three level offset 124
- Controlling document 125
- header file. See the 125
- Checking the meters 126
- DOCUMENT 127
Related products and manuals for Multifunctionals Kodak 7520
Multifunctionals Kodak 2J0686 User Manual
(198 pages)
(198 pages)
Multifunctionals Kodak i1800 Series User Manual
(101 pages)
(101 pages)
Multifunctionals Kodak 9.1 User Manual
(145 pages)
(145 pages)
Multifunctionals Kodak I600 User Manual
(83 pages)
(83 pages)
Multifunctionals Kodak 9090DB User Manual
(98 pages)
(98 pages)
Multifunctionals Kodak 2.2 User Manual
(127 pages)
(127 pages)
Multifunctionals Kodak HERO 7.1 User Manual
(127 pages)
(127 pages)
Multifunctionals Kodak 20R User Manual
(166 pages)
(166 pages)
Multifunctionals Kodak A-61555 User Manual
(108 pages)
(108 pages)
Multifunctionals Kodak 5.1 User Manual
(115 pages)
(115 pages)
Multifunctionals Kodak 6J7611A User Manual
(80 pages)
(80 pages)
Multifunctionals Kodak 20P User Manual
(198 pages)
(198 pages)
Multifunctionals Kodak 3953783 Datasheet
(2 pages)
(2 pages)
Multifunctionals Kodak ESP 5210 User's Guide
(72 pages)
(72 pages)
Multifunctionals Kodak ESP 5250 User's Guide
(18 pages)
(18 pages)
© 2020, manymanuals.com. All rights reserved. | 0.155 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals