Kodak 9020 User Manual download pdf (Page 7)

. Connect your EKTAPRO Slide Projector

to the mains with the mains lead . (UK users

note: A suitable fused 13A plug must be

fitted. See instructions on cable!)

. Turn on the mains switch (34).

The projector is switched on and ready for

use. The red LED (18) is on; lamp and fan are

switched off. I.e. the projector stays in a

"silent" mode. With any strike on a key

(such as transport, standby, ..) lamp and fan

will be switched on.

Note:

If a problem on the slide change is

detected, the red LED (18) (operation

indicator) will start to blink and the

projector can no longer be operated

(see Trouble Shooting Guide, page 34).

Switching-on the projector

EKTAPRO Slide Projectors will be exported throughout the world to countries with

differing mains voltages. The projectors are already set during manufacture to a fixed

mains voltage.

Shipments to countries with 100 or 120 V mains will be equipped with a 4 A slow blow/

250 V fuse. A spare fuse for replacement is also supplied.

Shipments to countries with 220, 230 or 240 V mains will be equipped with a T 2A L/

250 V fuse. A spare fuse for replacement is also supplied.

Before you switch on your projector ensure that the voltage is correctly adjusted! An

incorrectly adjusted mains voltage can damage the projector! The voltage indicator

(30) must show your country´s actual mains voltage!

Setting of a different operation voltage

WARNING

For safety, the mains lead must be unplugged!

Important:

Ensure that the 100 and 120 V setting uses a different fuse to the 220 -240 V setting.

See text above!

1. Unlock the fuse link compartment (31) by using a screwdriver and pull

compartment out.

2. Push the fuse link (32) into the compartment so -

3. - that the applied voltage can be seen in the window (30) of the compartment.

. Push the loaded compartment (with mounting underneath) firmly into the

projector opening provided.

Check voltage setting

140

Tray setting

Round trays for both 80 slides and 140

slides can be used. The tray setting switch

(10) is set in the factory to accomodate the

80 tray. By using a small screwdriver, the

switch can be brought into the 140 position.

Caution

If the projector is not properly adjusted,

there will be transport problems!

You can only set the EKTAPRO 3020

before you switch on the projector!

Switching- on the

projector

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments

Kodak 9020 User Manual Page 7

Comments to this Manuals

Related products and manuals for Projectors Kodak 9020