Kodak ESP 7250 User Manual download pdf (Page 11)

www.kodak.com/go/aiosupport 5

Networking Your Printer

This section explains how to configure or change your network settings.

Connecting to a wireless network

To connect your printer to an 802.11 wireless (Wi-Fi) network, refer to the following

information.

Before you connect

You need:

• A computer equipped with a network interface card or wireless networking

support.

• A working 802.11 wireless network. Kodak recommends that you use a wireless

access point/router that uses Dynamic Host Configuration Protocol (DHCP).

• To determine whether your wireless router supports Wi-Fi Protected Setup

(WPS).

• Your network name (SSID - Service Set Identifier). You can obtain your SSID

from the wireless access point, most commonly a router, using the router’s

embedded Web server. See the manufacturer’s documentation provided with

your wireless system for more information.

IMPORTANT: The SSID is case sensitive.

• Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access

(WPA/WPA2) passphrase.

• To temporarily disable your firewall until the printer is successfully installed and

communicating. For information, go to www.kodak.com/go/inkjetnetworking.

Using the LCD keyboard

When you need to enter letters or numbers, a keyboard appears on the LCD.

On the printer, press , , or to select the letters and numbers, using the

correct uppercase and lowercase letters. Press

OK after each character. When you

are done, select

DONE, then press OK.

• To erase a character, select

BKSP (backspace), then press OK.

• To change from uppercase to lowercase, select

abc/123, then press OK.

• To change from lowercase to uppercase, select

ABC/123, then press OK.

• To enter punctuation or symbols, select

!@#, then press OK.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 94 95

No comments

Kodak ESP 7250 User Manual Page 11