Kodak EX1011 User Manual download pdf (Page 18)

Appendix

18 www.kodak.com/go/easysharecenter

different. Unless a specific Kodak warranty is communicated to the purchaser in writing by a Kodak company,

no warranty or liability exists beyond any minimum requirements imposed by law, even though defect, damage,

or loss may be by negligence or other act.

FCC compliance and advisory

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures: 1) reorient or relocate the receiving antenna; 2) increase the separation between the

equipment and the receiver; 3) connect the equipment to an outlet on a circuit different from that to which the

receiver is connected; 4) consult the dealer or an experienced radio/TV technician for additional suggestions.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment. Where shielded interface cables have been provided with the

product or specified additional components or accessories elsewhere defined to be used with the installation of

the product, they must be used in order to ensure compliance with FCC regulation.

FCC and Industry Canada

This device complies with Industry Canada RSS-210 and FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Hereby, Eastman Kodak Company declares that this Kodak product is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC.

This digital picture frame EX811 and EX1011 transmits in 10dBm. In France, the power level is limited to

Kodak EasyShare digital picture frame

urg_00721.book Page 18 Wednesday, January 24, 2007 1:05 PM

1 2 ... 13 14 15 16 17 18 19

No comments

Kodak EX1011 User Manual Page 18