Kodak EKTAPRO 7020 User Manual download pdf (Page 4)

Electrical Approvals

The KODAK EKTAPRO 3020/4020/5020/7020/9020 Slide Projec-

tor complies with International Safety requirements and bears the

following safety marks:

 UL (Underwriter Laboratories Inc.)

 CSA (Canadian Standards Association)

 VDE (Verband Deutscher Elektrotechniker)

CE Conformity Mark

To show compliance with EMV-Directive 89/336/EEC and product

safety requirements, the slide projector bears the CE mark.

EKTAPRO 3020

In case of extreme mains disturbances problems with lamp flashing and/or

jamming may occur. In this case please switch the projector off and on again!

In case of a jam, please refer also to Possible problems during operation as

written in the manual on page 34. (Please keep the tray position in mind

before switching on the projector. With the random access function of the

IR remote control or the rapid search via the reverse transport button you

will easily come back to this position.)

EKTAPRO 4020, 5020, 7020, 9020

The projector is correspondingly programmed to prevent it from becoming

uncontrollable in the case of severe mains disturbances. Should such

disturbances occur, the projector resets itself, i.e. it brings the tray into zero

position and resynchronises itself. It is then fully operative again and ready

for use.

Radio interference:

EEC directive 89/336

Australia standards AS 1044

RFS49 ISSUES July 1989

VCCI Regulations Nov. 1987 Class 2

Part 15 of FCC Rules Subpart J Class B

Canadian DOC C 108,8 -M 1983 Class B

Note: This digital apparatus does not exceed the Class B limits for radio noise

emissions from digital apparatus set out in the Radio Interference regulations

of the Canadian Department of Communications.

Note: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technican for help.

Electrical Approvals and

Conformity Mark

english

1 2 3 4 5 6 7 8 9 ... 25 26

Comments to this Manuals

No comments

Kodak EKTAPRO 7020 User Manual Page 4

Comments to this Manuals