Kodak I600 User Manual download pdf (Page 8)

2-4 A-61504 April 2007

Some error conditions disable scanning and cause the document

transport to stop. This is done to prevent additional images from

entering the image buffer while allowing the host to perform fault

recovery activities.

NOTE: The scanner cannot determine exactly which images were

affected by the error and which images were not.

If an error occurs that disables the scanner, the host can continue to

read images from the image buffer without enabling the scanner.

However, when the image buffer has been emptied, an error will be

generated indicating fault recovery is required. This differentiates

between an end-of-job disable and a disable caused by an error. The

operator may continue scanning documents after the host enables the

scanner.

Controlling image

transfer order

This section provides job stream examples which can be used in

scanning applications.

The host application is responsible for determining the order in which

the scanner returns images. Front images must always be retrieved

before rear images.

Black and white only -

duplex

This job stream is available for all i600 Series Scanners.

1. Prepare documents.

2. Start the scanner to do black and white duplex scanning (front black

and white and rear black and white).

3. Setup the scanner to retrieve black and white images.

4. Enable the scanner and start polling.

Loop

Read front black and white image header

Read front black and white image

Read rear black and white image header

Read rear black and white image

End loop

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 82 83

No comments

Kodak I600 User Manual Page 8