Kodak Z1015 IS User Manual download pdf (Page 26)

Appendix

26 www.kodak.com/go/easysharecenter

facilities or services, or claims of your customers for such damages resulting from the purchase, use, or failure of

the Product), regardless of cause or for breach of any written or implied warranty is expressly disclaimed.

Your rights

Some states or jurisdictions do not allow exclusion or limitation of incidental or consequential damages, so the

above limitation or exclusion may not apply to you. Some states or jurisdictions do not allow limitations on how

long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific

rights, and you may have other rights which vary from state to state or by jurisdiction.

Outside the United States and Canada

In countries other than the United States and Canada, the terms and conditions of this warranty may be

different. Unless a specific Kodak warranty is communicated to the purchaser in writing by a Kodak company,

no warranty or liability exists beyond any minimum requirements imposed by law, even though defect, damage,

or loss may be by negligence or other act.

Regulatory compliance

FCC compliance and advisory

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed or used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures: 1) reorient or relocate the receiving antenna; 2) increase the separation between the

equipment and the receiver; 3) connect the equipment to an outlet on a circuit different from that to which the

receiver is connected; 4) consult the dealer or an experienced radio/TV technician for additional suggestions.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment. Where shielded interface cables have been provided with the

Kodak EasyShare Z1015 IS digital camera

urg_00908.book Page 26 Friday, October 17, 2008 9:06 AM

1 2 ... 21 22 23 24 25 26 27 28 29

No comments

Kodak Z1015 IS User Manual Page 26